The second model in the attached grid does not conserve energy. It can probably be seen with the single model, but i haven't tried that. An additional problem is that execution continues after this problem is found! Here is the output concerned the bad energy conservation.
DISASTER This calculation DID NOT CONSERVE ENERGY[[BR]]
badprt: all entries with greater than 2.00% of incident continuum follow.
badprt: Intensities are relative to total energy radiated.
Sum of energy in recombination lines is 1.08e+012 relative to total incident radiation is 4.01e-001
all strong information lines
line wl ener/total
Ni 3 1.659A 0.097 r
Ni 3 1.655A 0.194 r
Ni 3 1.495A 0.027 r
all strong cooling lines
line wl ener/total
Sum of coolants (abs) = 1.76e+012 (rel)= 6.50e-001
HFBc 0 0.122 c
HFFc 0 0.084 c
Clin 912.0A 0.191 c
CION 0 0.139 c
Ca 2 8579A 0.022 c
H-FB 0 0.054 c
H2+ 0 0.020 c
all strong heating lines
line wl ener/total
Sum of heat (abs) = 2.48e+012 (rel)= 9.19e-001
BFH1 0 0.026 h
BFHe 0 0.117 h
TotM 0 0.667 h
H- H 0 0.076 h
